Shop fox W1835 Specifications download pdf (Page 19)

-17-

Model W1835 (For Machines Mfg. Since 12/12)

OPERATIONS

Changing Blades

Severe lacerations, amputation, or

death can occur if blade changing/

adjustment is attempted while saw is

connected to power. Always unplug

saw before changing or making any

adjustments to blade or riving knife,

or performing any maintenance to the

saw that would require direct physical

contact with the blade.

When changing saw blades, always keep the saw in an

upright position. Position the saw along the edge of a

workbench or table, so that the blade can be lowered

safely down below the surface edge of the workspace

while the saw remains upright.

To change the blade, do these steps:

1. DISCONNECT SAW FROM POWER!

2. Engage the plunge release and lower the blade down

far enough to expose the arbor bolt. Push the blade

lock (see Figure 9) and rotate the arbor bolt with a

5mm hex wrench until the blade locks in place.

3. With your free hand, turn the arbor bolt

counterclockwise with a 5mm hex wrench to loosen

it, as shown in Figure 10.

4. Once the arbor bolt has been loosened, use your

fingers to carefully remove it, along with the arbor

washer, then guide the blade down and out of the

saw.

5. When ready to insert a new blade, lower the saw

back down so that the arbor flange is visible. Insert

a new blade into the saw. Align the center of the

blade over the arbor flange and let it rest there.

6. Make sure grooves of the arbor washer are correctly

lined up with the flange and thread the arbor bolt

and washer into place with your free hand. The

correct order of installation is shown in Figure 11

for your reference.

7. Engage the blade lock to keep the arbor flange

steady, and tighten the arbor bolt firmly using a

5mm hex wrench.

Figure 10. Loosening arbor bolt.

Figure 11. Saw blade and blade-fastening

components.

Blade

Washer

Arbor

Bolt

Arbor

Flange

Figure 9. W1835 top view.

Blade

Lock

Plunge

Release

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments

Shop fox W1835 Specifications Page 19

Comments to this Manuals